UTG 11mm (3/8") Dovetail to Weaver Adapter, 2pcs

Use to attach a reddot to a break- barrel with 3/8in groove. Worked perfectly.

Nothing.

You get 2 per package.

fixed my problem

instructions are vague

Very easy to use and well built. Best value for the money I have found yet

N/A

I have them on 3 of my rifles

I am using these as a scope base for a valmet 412S over under rifle. Very satisfied so far has stood up to the recoil of a 9.3x74R rifle.

Would like a version in steel.

Much less expensive than custom mounts if you’re lucky enough to find them.

I have lots of Weaver type rings, and these adapters allow me to use those rings on my Dovetail airgun rails. What can I say, they are convenient and solve a practical problem.

Nothing. They are easy to use.

Offset stop pin allows some fore-back positioning of mounts by flipping adapter around. Otherwise see additional comments.

Tighter tolerance fit of alignment pins. Larger diameter and longer stop pin.

Do not work well for me with dovetails cut into round top receiver.

Alignment pins are a loose/sloppy fit in adapter halves. On round top receiver narrow half lacks support below and rotates inward when tightened reducing engagement with dovetail groove. As result when tightened to spec or subsequently even tighter scope and mount in either case will pop off rifle from springer recoil or if bumped.

With support from below on flat topped dovetail receiver the adapters probably would be fine.

Also note stop pin is very small diameter and short. Pin adjusts to either minimally engage with receiver or minimally thread into adapter, not long enough to engage both well.

Worked well on grooved receiver

If you are not mechanically adept, it may take you a while to figure out how to use them. Instructions would be nice

See above. While mine worked fine, I'm not sure they are installed according to the design

Probably the best invention of the 21st Century for active gunners! Having a few older dovetail pieces and with that attachment choice almost obsolete in these tactical times, this transition piece gives more flexibility for various newer pieces to be attached. The price point is just right to have extra in the gun box for spares.

Nothing I can think of at this time.

Sometimes these adapters are a little stiff out of the blister card so a few squeezes (or an extra small drop of oil to the springs) to limber them up will help when inserting in the piece to attach on the dovetail.

These adapters were exactly what I needed. I have many pairs of Weaver rings that are no longer useless. I may have to buy more air rifles to use them up.

Nothing.

Sets true, better than the china brand bought.

Dunno