TenPoint Raised Cheek Comb for Tech & Tactical Stock

This raised cheek riser provides the ideal height for eye alignment when using the Garmin or Burris X crossbow scope. Installation is super easy, as it utilizes an adhesive backing that sticks to the rubber cheek rest that comes on the bow. The one thing I highly recommend is to use washers under the screw heads so that the upper part of the cheek rest does not come loose from the lower screw anchor points.

I had a Burris Oracle X on my new crossbow and the raised comb made it much easier to get a good mounting position.

Easy upgrade for use with the Burris Oracle X. Much more comfortable with the cheek comb.

Won’t stick never has stuck from day 1 for as much as these guys charge for their bows you’d figure they’d put a little more thought and engineering into this

Fairly straight forward installation. Use a heat gun to soften the adhesive on the original comb. Peel it off, it left behind a double sided adhesive tape, that peeled off in one piece. Remove the screws on the stock, so it splits in half. You's see a metal pin behind the pad on the grip. Remove the pin and the pad. Place the pressure switch into the spot the pad was in. loop the cable down to the bottom of the pistol grip then back up along the stock. I found it easier to have the crossbow in one half of the stock, run the wire in the groove, then put the other half of the stock in place. Installed on a Havoc RS-440

Helps steady bow when sighting the Oracle X scope in and shooting.

Working and helping with sighting in my burris scope, height to scope is right on

The replacement cheek comb was a Perfect fit , it properly adjusted the comb height to adjust for my ATN digital scope height

Haven't installed it yet bought it to use with the burris scope going to install it on my new stealth 450

Does not fit will be asking for a refund or exchange