Hatsan Air Cylinder, Fits Various Hatsan Air Rifles

Fits my Hatsan Flash QE just fine after swapping the OEM ones to the new tube.

Factory improver air tube size.

Good concept.

I does not fit my 25 Cal. Hatsan Invader

This item showed that it fits Hatsan Invader 25; however, it DOES NOT fit, due to the air cylinder's frontal attachment.

Does what I bought it for, put on a flash. Plan on recreating the YT guys build of a flash. Minus the LW barrel.

Make sure gauge is accurate. Off by maybe 300 psi..

Removable cylinder, 30 shots before refilling and consistency of the pressure release for pellet accuracy.

Over the last three years I have shot the Hatsan 25 caliber the original and the secondary cylinder developed air leaks. I have tried to order a seal kit for the cylinders but received seal kits for the rifle. Utube enabled me to take the pressure tube apart but there are parts in the pressure release mechanism that are not provided in the kits and I am unable to find an air rifle repair station to repair them. I have ordered a third cylinder and am waiting on a 30 day delivery at this time.

I have enjoyed my German made pellet rifles over the past 30+ years but spring replacement or repair stations have become difficult to find. Air pressure cylinders are like the springs in that without them you have a $500 to $700 clubs.

for info

couldn't use

This says it fits the Hatsan Galatian, however it will not fit the Hatsan Galatian Tact Auto. The diameter and configuration of the piece the screws into the rifle are different.

Quality made. No cloudy glass on pressure gauge like original one on rifle

nothing

A little silicone grease applied to O-rings is a good idea.

Dear I received my item with perfect condition and the same as required. Thanks

As I am new customer I sow everything things perfect

Thanks

exact same tube that came with my BT65 sb .25. gauge is the same and all.

nothing

the more tubes the better! i fill them up the night before going shooting. and no pumping all day long. they are easier to carry then a big bulky air tank to.

The cylinder is actually better than the original,the original has a suspect gauge.the new cylinder holds the air perfect no leaks Im getting about 40 good shots starting at 935 fps reaching 980 . Very happy with the cylinder.

I like the brass cap to protect the valve.

The gauge on it says one thing and my compressor says another. If I filled it according to the built in gauge, it would likely burst. It makes it hard to tell if it's low on pressure or filled to 200 bar.

The life expectancy for this cylinder is 10 years. Hatsan says not to use it past 10 years and to discard it