Benjamin Trail NP Mark II Air Pistol

Once I learned the trick to cocking by reading the non-associated pro reviewer's explanation of how to do it properly the has shown itself to be a fun nice & powerful break barrel pistol!

Improve accuracy. Tested it with alloys I know in my old 1377 are very accurate!

Great value for power pistol!

Just received this and am very pleased with it. . . .glad I read the reviews. I couldn’t open (cock) it and prior to reading the directions, I remembered the ‘tap’ suggestion. It works! And I found no problems with the trigger. I did note that when you set it down on a flat surface, the safety can easily be deactivated. I’m surprised that was not addressed. Be careful. Great pistol, though. . . Love their products. I have their long rifle and when I finally ‘woke up’ and purchased a compressor. . .new ballgame!

Nothing..just watch that safety. Lay it down on the R side.

You’ll love it!.

The fiber optic sights have good visibility in broad daylight. It has good velocity with 8 grain pellets - just over 500 fps

I had to grind down some of the black plastic molding on the top of front sight because the excess plastic obscured my sight picture. The grip is like a brick - it would be nice to have some contours for your fingers. The trigger adjustment screw needs some threadlock. It tends to back out while shooting if it is not tightly seated.

After sighting the pistol using a rest and obtaining a good group, if I removed the rest and shot unsupported, my group was 4 to 5 inches lower at 30 feet.
Furthermore, when shooting unsupported, I noticed that removing the cocking assist raised my group 2 - 3 inches at 15 feet.

Waste of money

Better quality control

Mined didn't have half the power advertised ( Chrono). Seal was bad. Through it out.

It is well built...

WOW, where to start. The trigger pull at 6+ lbs. is awful. Forget shooting without a bench rest. It pull one way or the other... The sight is useless, I took it off and replaced with a dot scope. The attachment for cocking is of little use. If you can't cock it with just the barrel, your not strong enough to safely hold the pistol to begin with.

All in all after I searched the net for reasonable solutions to its trigger pull, there was hope.
removing the front spring reduced the pull to under 3 lbs., your still going to need a bench rest or bags to keep the pistol steady but after all that, it was dead center at 10yds. all the time...

love the pistol- but

see below

There seems to be a problem with the air connection - between the gun air adapter and the hose adapter, I have to fidget with this connection , before the air will fill the container, I have called the tech support and they sent me another hose connection- it seem that there is a very small gap that air will escape out of. I have to use silicone oil at this connection - before it actually makes an air connection. metric ? american standard ?conection. !!

Nicely Styled .Very accurate with scope and trigger mod.

Horrible trigger. Very long travel and probably around 6-7 lbs pull.

I modified the trigger by removing the trigger blade spring (its on youtube) and replaced the 8mm M3 seer screw with a M3 10mm one. About a 3 lb pull now and makes this gun a delight to shoot. Safety still works and does not fire when dropped. I make no claim of safety if others do this however.

good exercise, fun to shoot and nice sights.

nothing

not too hard to cock, I am 80 yrs. and can do it.

Price was fair, relatively easy to cock for a 65 year old small man, easy to load, accuracy limited by the cheap plastic sights.

Eliminate 3 dot system on sights. Very hard to judge elevation, windage no problem. Trigger pull very hard. Limit distance to 10 meters for pests. When shot at typical empty can, light pellets break one side and make dent on far sid of can, pellet stays inside can. Heavier pellets go through can both sides at close distance. Same way when shooting into gallon milk jug filled with water at 10 meters. Heavier pellets break through. Light ones stay inside container.

Get on you tube, lighten trigger pull by removing one spring. Easy to disassemble. Probably will remove rear sight and install Red Dot or low power scope to reach full accuracy potential.

Its a break barrel so no compressors or co2 needed. Adjustable rear sight with high visibility on both. Cocking extension for ease of use Pretty accurate once you adjust the rear sight. Good power.

My number 1 gripe with this pistol is the non functional front picatinny rail. Fairly hard to cock without extension Horrendous trigger pull.

I bought this gun with the intention of building a nice, cheap to run rat slaying machine. The key feature that sold me on this gun was the front picatinny rail which I wanted to mount a laser light combo. The distance I would be shooting at is pretty fixed so a zeroed in laser would have been awesome. I can sadly say that if you are buying this gun with the intention of utilizing the front rail, dont do it. The rail is totally useless. Had I known this, knowing what I was trying to achieve I would have gone with something else. I really wanted this to work.