Quick-Disconnect Male Fitting + O-Ring

Beautiful fit, gas tight when finger tight, nice black finish, outstanding upgrade for this 909s

The only thing I would change would be knowing about it a few years earlier. Excellent piece of equipment I highly recommend it.

If it fits your gun, buy it. I believe you will not be disappointed.

Absolutely great customer service pointed me in the right direction and got my air gun up and running with this adapter

Had a problem connecting air Seneca Eagle Claw! Greg at Customer Service was wonderful! And Tracy at Air Venturi worked with Greg at Pyramid and sent me the correct Part to solve the Problem! How wonderful to get help and Service after the sale! I give both Company 5 stars and will tell others about Pyramid not forgeting Buyers like other Air GunSellers Do! Thank You Again Pyramid !

If your Buying an Air Gun it not always the Price ! Even though Pyramid Prices are great! But service after the Sale is so lmportant! Pyramid Service is Number 1 in my book! Earl W

It replaced the probe inlet on my old SamYang Dragon Claw with the single tank.

A little less stressful on the install: It fits but it fits so tightly I originally thought I was doing something wrong or I got the wrong part. It doesn't visually match what came out of the airgun, but it did work. It requires a lot more tightening down with a strong wrench than I liked, but so far so good. I am happy to have the quick disconnect on this gun, not that old probe.

You will initially think the threads don't line up on your Seneca or old SamYang big bore air rifle. Check EVERY ONE of the Q&A of this item and see what other people experienced with their guns. If you decide to do this repair/swap/modification, you will want to put the quick disconnect on the gun finger tight to fully ensure you have not cross threaded the thing. Then gently start to tighten it down a couple turns. After this, hook up your hand pump. Don't use a compressor or tank! You want a small amount of air psi. Pump a few times and tighten while the air hisses out. repeat this until the rubber O-Ring is fully smashed between the parts on the inside... that's when the air will stop hissing out. Be gentle, be slow, and be careful. Good Luck.
This was my experience. Your experience may vary, so make this repair/modification at your own risk.

Didn't work as hoped

Correct thread and size

Definitely will not fir Umerex Gauntlet air tank

Nothing

Make sure it fits the product .

Wrong threads. Be careful. You could destroy the threads on your rifle.

It is easy to install,

Make a better valve, I have two Benjamins Marauder and but valves failed after a short period. I retired the valves and put teflon tape on the treads and both worked. Benjamin needs to do something with these valves.

Always carry a spare especially if you are doing any kind of competition shooting. I hope one would have a compressor or you will be pumping for a long tiring time. If I knew about this before buying these Air Rifles I would have looked for a different. brand,

allowed me to ditch the probe type fill on my Sumatra

This was not machined correctly. The male foster is not long enough, and did not allow the female coupler on my compressor to seat and lock into place. I had to mill the base of if about 2mm further down into the nut to allow it to couple properly. The threaded portion also is not the same shape or dimension as the Sumatra fill probe receiver, and required adding an extra O-ring to get a seal. Still leaks when filled over 200 Bar

Not a simple swap for a Career or Sumatra rifle.

ease of installation, drops right in. Now all my rifles use the same fill fitting.

Very Happy Fits my Sam Yang 909s So much better than the factory fill probe that comes with the gun. Since installing its so much easer then factory probe ALL PCP Air Rifles should be Made with a Male Quick Disconnect AND NOT with the Probe. and Made in USA

So much better than the factory fill probe that comes with the gun. Since installing this I have lost no air due to the factory probe