SPECIFICATIONS
WARNING
HOW TO OPERATE:
CAUTION: Be sure gun is always pointed in a safe direction. 
Step 1. OPEN STOCK
Press down the butt latch (1) and turn the stock (5) clockwise to position, the stock is in open state. To fold the stock, press down the butt latch and turn the stock counter clockwise to the right side of the rifle, then the stock is in the folding state.
Step 2. PREPARE FOR AIR COMPRESSING
Set the safety device on the front of stock, letting the arrow be in alignment with "I" (the arrow shall be in alignment with "O" when under unfiring conditions.) Hold the front portion of hand guard (9) with left hand and open the lock plate (7) with right hand with the plate being against the right side of one's abdomen. Turn the link (6) for air compressing.
Step 3. LOAD AND COCK
While the lock plate is open, turn the link and to power air cylinder (3) moves rearward by 40mm approximately.
(At this time, the ratchet should engage with the rack.) Load a lead pellet into the chamber with hand, then resume turning the link until the trigger is engaged.
Step 4. ROTATE LINK
Turn the link counter clockwise until the lock plate snapped in the pullrod(8) slot. (If the link can not be turned back, it means that engage the ratchet still with the rack. Just turn the link rearward to release it. )
STEP 5. AIM AND SHOOT
Adjust the rear sight (2) according to the firing range. Direct the top of front sight (4) at the object from the upper plane of notch of the rear sight and press the trigger to fire.
CAUTION: Do not leave your gun pumped for an extended period of time. This could result in a time delay from the time the trigger is pulled until the projectile is expelled from the gun.
WARNING: If a pellet does not fire after, completing the operation steps, the gun is jummed. This is a dangerous condition.
Repeat cock operation and fire again. If a projectile still does not fire, follow these steps carefully:
1. Open air cylinder.
2. Put trigger safety "O".
3. Clear barrel by running a cleaning rod through from the muzzle end. Do not reuse this pellet.
SPECIFICATIONS
WARNING